Category: Troubleshooting

How to fix “Error mounting EFI on disk /dev/disk” errors

March 3, 2021

Verify that the EFI partition is on slice 1 by running the following command: diskutil list (note that the EFI partition is disk0s1) Verify that …

Read More

Inject AppleSSD driver in Winclone 8.2

November 4, 2020

Overview Migrating a Boot Camp partition from a older, non-T2 Mac can result in a blue screen with the error message (stop code) Inaccessible Boot …

Read More

Shrink/Expanding Boot Camp Partition with Winclone

February 3, 2020

Starting with Winclone 7, the options to shrink or expand a Boot Camp partition only appear when block-based imaging has been selected. Shrinking is not …

Read More

Make Legacy Bootable in Winclone 8

October 1, 2019

Windows can boot in EFI or Legacy mode, depending on the Windows version and the type of Mac. Winclone will detect which boot mode to …

Read More

Make EFI Bootable With Winclone 8

October 1, 2019

Make EFI Bootable Windows can boot in EFI mode or Legacy mode, depending on the Windows version and the type of Mac. Winclone will detect …

Read More

Winclone License Key Registration Issues

October 1, 2018

If you are trying to activate Winclone and receive an error message such as “Registration Error:¬†Invalid License Key”, there are some steps you can take …

Read More

Restoring Winclone 7 (and later) Images to the 2018 MacBook Pro and 2017 iMac Pro (Macs with T2 Co-Processors)

September 16, 2018

Macs that have new T2 coprocessor may have issues booting from a restored Winclone image. These Macs include: 2018 MacBook Pro 2017 iMac Pro The …

Read More

Resolving INACCESSIBLE_BOOT_DEVICE Error after restoring Winclone image

August 19, 2018

When migrating Windows between different hardware or hard drives, Windows may start up with an INACCESSIBLE_BOOT_DEVICE error. This error is caused by the lack of …

Read More

Block Based and WIM Based Images in Winclone 7 and later

May 29, 2018

Winclone 7 (and later) has the ability to create Winclone images in either file-based¬†(WIM) or block-based mode. This article explains the difference between the two …

Read More

Inject Drivers into a Winclone Image

May 5, 2018

If you are having issues with initial boot after restoring a Winclone image to new hardware, you can inject basic drivers into the Winclone image using the DISM command line tool in Windows 10. This only works if Windows has been sysprep’ed prior to imaging.

Read More